Page 1 of 1
A30 motor currents for X,Y,Z axis motors
Posted: Sun Jun 16, 2019 3:50 am
by Seriogal
Decided to change stepper drivers in my A30. To properly adjust them it is needed to know stepper motor models or nominal current of these motors. Can anyone help me with this information? Thanks!
Re: A30 motor currents for X,Y,Z axis motors
Posted: Mon Jun 17, 2019 7:23 am
by Sa1Wales
This video says best is around 0.6 volts, his were set at nearly double that at defualt not sure if it will help but added the video as any reply is better than no replys. Hope its what your asking about.
Peter Homer made the video and seems informative.
https://www.youtube.com/watch?v=p_TpiZSebxw
Steve.