Another edition of the M201 printer firmware for the GTM32Pro vB controller board.
Posted: Wed Jun 19, 2019 11:33 pm
Hi all.
I will not wait any longer and give the users another version of the firmware for our printer model.
I was supposed to make the firmware available only after thorough testing. However, there is still no time.
So I release it earlier. Unfortunately, I am not able to say what changes have been made. The team that was responsible for the development for a long time no longer works for GT. I hope that more than just the version number label has changed.
What I want and what I want for you.
.
I've uploaded the firmware to my printer. It was also done by my friend from France (algernon).
The printers are still working.
. .
Once you have uploaded the new firmware, don't forget to enter the used settings again. Then it is worth to save them in the memory of the controller.

I will not wait any longer and give the users another version of the firmware for our printer model.

I was supposed to make the firmware available only after thorough testing. However, there is still no time.

So I release it earlier. Unfortunately, I am not able to say what changes have been made. The team that was responsible for the development for a long time no longer works for GT. I hope that more than just the version number label has changed.

What I want and what I want for you.

.
I've uploaded the firmware to my printer. It was also done by my friend from France (algernon).
The printers are still working.

. .
Once you have uploaded the new firmware, don't forget to enter the used settings again. Then it is worth to save them in the memory of the controller.
