M201 Printer Display Module Cover.
Posted: Thu Jun 20, 2019 4:26 pm
Hello.
I was asked to share my enclosure designs for the printer.
And here's the first one.
Right away my reset button is included in the set.
Watch, print and express your opinions.
After printing the case, I glued a copper adhesive tape inside to reduce the impact of electromagnetic interference.
.
.
.
If anyone would like to offer me a beer, they can do it by sending a small gift to my PayPal account at jjj.p@interia.pl
I was asked to share my enclosure designs for the printer.
And here's the first one.
Right away my reset button is included in the set.
Watch, print and express your opinions.
After printing the case, I glued a copper adhesive tape inside to reduce the impact of electromagnetic interference.
.
- obudowa_z_miedzianym_ekranem.jpg (344.53 KiB) Viewed 3615 times
- widok_po_zmontowaniu.jpg (296.26 KiB) Viewed 3612 times
If anyone would like to offer me a beer, they can do it by sending a small gift to my PayPal account at jjj.p@interia.pl