Page 1 of 1

Please share Prusa i3 A pro - M92 EEPROM - default Settings

Posted: Mon Jul 08, 2019 3:24 pm
by Softbot
Hi there,

I have messed up my M92 Settingin in the EPROM (Geeetech Prusa i3 A pro) and have not recorded the default setting :roll:

Can someone please share the default value, I would like to revert to default.

Command M503 will print the current value ... please see the guide below, I need the M92 / E setting
by https://mattshub.com/2017/04/19/extruder-calibration/

Re: Please share Prusa i3 A pro - M92 EEPROM - default Settings

Posted: Mon Jul 08, 2019 3:46 pm
by William

Re: Please share Prusa i3 A pro - M92 EEPROM - default Settings

Posted: Mon Jul 08, 2019 4:19 pm
by Softbot
Hi William,
I have saved wrong setting in the EEPROM using M500 command
Command 501 will restore the settings from the EEPROM or in other words the wrong settings I have saved before.
Im looking for is the factory value which have been set by geeetech, not sure if there is a repository to get the factory default values?
Thanks!

Re: Please share Prusa i3 A pro - M92 EEPROM - default Settings

Posted: Mon Jul 08, 2019 4:21 pm
by William
You can try resetting.

Re: Please share Prusa i3 A pro - M92 EEPROM - default Settings

Posted: Tue Jul 09, 2019 2:44 pm
by Softbot
Hi there,
I managed to restore settings using M502 (factory defaults) and saved setting using M500
This worked for me, all settings back and printer functional :D
The other hint was to check firmware conf file which must contain the default values ...
I found some factory values in conf file, but not my Extruder value "93" :roll: wondering which firmware is installed
Thanks!