Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
http://forum.geeetech.com/

Z-Axis Calibration

http://forum.geeetech.com/viewtopic.php?t=69503

Page 1 of 1

Z-Axis Calibration

Posted: Sat Nov 02, 2019 11:24 pm
by donix
since my Z-Axis moves jut 30mm insted of 200mm, i wanted to adjust the default_axis_steps_per_unit.
Changing the parameters (configuration.h) works for X and Y axis, but the Z-Axis stays unchanged at 400 !!

Re: Z-Axis Calibration

Posted: Mon Nov 04, 2019 9:28 am
by William
Hi,If you want to change the step value, you can try to change it and save it on the screen.
All times are UTC+08:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited