Réparation boot loader main board 2560 V3 A10M
Posted: Sat Dec 07, 2019 4:55 pm
Bonjour,
voici une méthode pour réparer le Boot loader d'une carte 2560 V3 printer GEEETECH A10M
Le lien de mon partage est Français ICI https://www.lesimprimantes3d.fr/forum/t ... ent=316310
Cordialement Francis
çà fonctionne très bien de nouveau !
Following a TV payment of the update of MARLIN V1.19 that does not work! on my GEEETECH A10M I accidentally lost the boot loader of the GT2560 V3?
Here I searched on the net, no tutorial or recovery procedure of the boot loader.
I need to restore the boot loader with an ARDUINO UNO configured in ICSP.
But here I can not find any PIN or ICSP connection on the GT2560 board. (how do the Chinese ???)
I do not want to start making micro welds as this will damage the 2563 V3 hand of the GEEETECH A10M printer.
I have the solution to make the cabling of the ICSP I ordered this to connect to an external module allowing me to achieve clean welds without generating electrostatic discharges on the GT2560.
After about 3 weeks, I finally received the conductive sheet 40 pins x0.5 mm and the connector of the tablecloth that goes well!
voici une méthode pour réparer le Boot loader d'une carte 2560 V3 printer GEEETECH A10M
Le lien de mon partage est Français ICI https://www.lesimprimantes3d.fr/forum/t ... ent=316310
Cordialement Francis
çà fonctionne très bien de nouveau !Following a TV payment of the update of MARLIN V1.19 that does not work! on my GEEETECH A10M I accidentally lost the boot loader of the GT2560 V3?
Here I searched on the net, no tutorial or recovery procedure of the boot loader.
I need to restore the boot loader with an ARDUINO UNO configured in ICSP.
But here I can not find any PIN or ICSP connection on the GT2560 board. (how do the Chinese ???)
I do not want to start making micro welds as this will damage the 2563 V3 hand of the GEEETECH A10M printer.
I have the solution to make the cabling of the ICSP I ordered this to connect to an external module allowing me to achieve clean welds without generating electrostatic discharges on the GT2560.
After about 3 weeks, I finally received the conductive sheet 40 pins x0.5 mm and the connector of the tablecloth that goes well!