Geetech 3I Pro Woody
Posted: Mon Apr 20, 2020 1:57 pm
Ok I have been kicking around the 3D print Community since 2010 and I finally got a Woody on Amazon.ca.
I have had a Persa Mendel/Mono/3II a Hyper Cube XD and a TEVO Tarantula..
so I am no stranger to tweaking Marlin/Sprinter firmware.
so Any suggestion as to what to add to my Woody would be appreciated...
I will add my 20 years using 3d printers to your forum and try my best to help all users with there printing problems.
Regards
Justin Schubert
I have had a Persa Mendel/Mono/3II a Hyper Cube XD and a TEVO Tarantula..
so I am no stranger to tweaking Marlin/Sprinter firmware.
so Any suggestion as to what to add to my Woody would be appreciated...
I will add my 20 years using 3d printers to your forum and try my best to help all users with there printing problems.
Regards
Justin Schubert