E180 priting bed is shaking
Posted: Wed May 27, 2020 4:28 pm
Hi All!
It's my first post here
I'm new with Geeetech E180, but with some experience with other 3d printers.
After a first trial (Belem Tower, located in Lisbon - Portugal), I noticed that the printer bed shakes a lot. I decided to unplug the bed and I noticed that there is a conveyor belt (obvious) that I can adjust, attached to a Bosch aluminium profile suported by 4 bearings. And the aluminium profile shakes between the bearings (these bearing are covered by rubber).
Any one noticed this??
Thanks!
It's my first post here
I'm new with Geeetech E180, but with some experience with other 3d printers.After a first trial (Belem Tower, located in Lisbon - Portugal), I noticed that the printer bed shakes a lot. I decided to unplug the bed and I noticed that there is a conveyor belt (obvious) that I can adjust, attached to a Bosch aluminium profile suported by 4 bearings. And the aluminium profile shakes between the bearings (these bearing are covered by rubber).
Any one noticed this??
Thanks!