A30M glogging hotend
Posted: Tue Jul 07, 2020 12:17 am
I have a problem with a glogged A30M hotend.
After running for 18 hours printing with Geeetech wood filament, when it suddenly glogged. I have managed to unglogg the left extruder, but the right one is stuck, and it seems like the problem is at the top where the boden tube is entering the hotend.
Do you have any suggestions how to clean this?
After running for 18 hours printing with Geeetech wood filament, when it suddenly glogged. I have managed to unglogg the left extruder, but the right one is stuck, and it seems like the problem is at the top where the boden tube is entering the hotend.
Do you have any suggestions how to clean this?