Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
http://forum.geeetech.com/

A10M Auto Bed Leveling Fails Hits The 'Y Axis Switch'.

http://forum.geeetech.com/viewtopic.php?t=71156

Page 1 of 1

A10M Auto Bed Leveling Fails Hits The 'Y Axis Switch'.

Posted: Mon Aug 31, 2020 8:20 pm
by loky
When I auto bed level the bed. it doesn't level it like it should do it. it probes the wrong places.
'Pls look at the video.( https://youtu.be/XvewuFwzRoo )

Re: A10M Auto Bed Leveling Fails Hits The 'Y Axis Switch'.

Posted: Tue Sep 01, 2020 10:10 am
by William
Hello, this is a firmware problem. The leveling is too close to the edge. You can remove the clamp and level it again.
All times are UTC+08:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited