Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
http://forum.geeetech.com/

Problem with A20 and Overhang

http://forum.geeetech.com/viewtopic.php?t=71790

Page 1 of 1

Problem with A20 and Overhang

Posted: Sun Nov 22, 2020 9:37 pm
by Zakzak3d
Hi all,

I have a Geeetech A20 and I struggle to get out clean overhangs, I tested to print a temperature tower, but I still have the same problem, the pla is curving upwards and it doesn't matter temperature.
Do you have any leads for me to resolve this problem.
Thank you for your help !
127236502_10158753451299417_2190868796134562405_o.jpg
127236502_10158753451299417_2190868796134562405_o.jpg (38.81 KiB) Viewed 6564 times
126945261_10158753451549417_4312718875498935592_o.jpg
126945261_10158753451549417_4312718875498935592_o.jpg (44.99 KiB) Viewed 6564 times
126910316_10158753451209417_2509540547769375072_o.jpg
126910316_10158753451209417_2509540547769375072_o.jpg (66.42 KiB) Viewed 6564 times

Re: Problem with A20 and Overhang

Posted: Mon Nov 23, 2020 1:02 am
by Zakzak3d
After many try I think I have found the solution, it's look like I haven't a fan duct near the Nuzzle to cool the model, Do you know where I can found 3d model to print a fan duct for the fan :
All times are UTC+08:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited