A30T 3D Touch PRO
Posted: Sun Dec 26, 2021 11:58 pm
I'm having problems setting up auto-leveling on my brand new A30T printer.
Bought and installed the 3Dtouch V3.2 pro sensor. Everything seems to work fine, sensor deployment, alarm reset etc. If I try to perform automatic leveling the printer goes into a home position and tries to deploy the sensor not even over the heatbed - always resulting in an error...
I thought it was supposed to go to the center first and then start...
Any ideas/help would be highly appreciated - flashed and tried several firmware options, so there should be no issue with that...
Thanks in advance
Bought and installed the 3Dtouch V3.2 pro sensor. Everything seems to work fine, sensor deployment, alarm reset etc. If I try to perform automatic leveling the printer goes into a home position and tries to deploy the sensor not even over the heatbed - always resulting in an error...
I thought it was supposed to go to the center first and then start...
Any ideas/help would be highly appreciated - flashed and tried several firmware options, so there should be no issue with that...
Thanks in advance