Prusa i3 Pro W 3d touch not working
Posted: Tue Feb 01, 2022 10:36 pm
hi all i downloaded the firmware for my printer here: https://snaptube.cam/ and it says with 3d touch but i seem to not be able to get the 3d touch working no mater what i do im just wondering if anyone cant help
the light is on and turns of when i pull it down and when i first turn on the printer it goes up and down.
I have put g29 after g28 but even when i send commands it doesnt move so i think its a firmware issue but it might be a wiring issue i dont know. i have checked all the wires go to the right place but i dont know how to check if the wires are getting the signals. does anyone have any experience with the 3d sensor and geetech pro W's?
any help is appreciated
the light is on and turns of when i pull it down and when i first turn on the printer it goes up and down.
I have put g29 after g28 but even when i send commands it doesnt move so i think its a firmware issue but it might be a wiring issue i dont know. i have checked all the wires go to the right place but i dont know how to check if the wires are getting the signals. does anyone have any experience with the 3d sensor and geetech pro W's?
any help is appreciated