How to reinforce the Y-axis with the stand
Posted: Wed Apr 20, 2022 12:34 am
Hi,
I am a bit unhappy with the stability of my I3 Aluminum.
When I press the button to release the filament from the extruder I can see how the whole upper part is moving. I am a bit afraid that this will affect my bed calibration.
Is there any way to reinforce the printer mechanically?
The idea is to bulit a strut between the M10 threaded ends of the Y-axis and the upper part of the printer so the whole construction is a bit more solid.
https://100001.onl/ https://1921681254.mx/
Has someone ever done such a modification?
Best regards.
I am a bit unhappy with the stability of my I3 Aluminum.
When I press the button to release the filament from the extruder I can see how the whole upper part is moving. I am a bit afraid that this will affect my bed calibration.
Is there any way to reinforce the printer mechanically?
The idea is to bulit a strut between the M10 threaded ends of the Y-axis and the upper part of the printer so the whole construction is a bit more solid.
https://100001.onl/ https://1921681254.mx/
Has someone ever done such a modification?
Best regards.