Help with purge line Gcode
Posted: Tue Jul 26, 2022 2:55 pm
Hi,
Since i updated Cura to 4.8.0, it seems the purge line disapperead.
I tried some code but no one was good.
Can someone share a simple startup purge line Gcode to add to Cura for my A20M ? This would help some filament stick better on first layer. Now i have to manually remove the few millimeters of filament down the nozzle just before print starts.
Best regards.
Since i updated Cura to 4.8.0, it seems the purge line disapperead.
I tried some code but no one was good.
Can someone share a simple startup purge line Gcode to add to Cura for my A20M ? This would help some filament stick better on first layer. Now i have to manually remove the few millimeters of filament down the nozzle just before print starts.
Best regards.