Geeetech

Hi.
Need to replace stainless steel extruder pipe screw (inner diameter 2 mm), where I can buy it ?
Thanks

Now I have a problem with end stops (using marlin firmware), in case when end stop is activated whole system is going down/disconnected. Can you please help me to solve this issue ?

1. It's works now, thanks for help (please update your documentation/info) !
2. But now I have another problem - when HOTBED is connected (even there is no power input + USB/board is connected to PC) for some reason fuse (that related to hotbed) becomes extremely hot... what wrong now ? Maybe wiring ...

Still doesn't working. Please watch my video about this issue: https://www.youtube.com/watch?v=Xw6BYYaCDMI

Hi. Still not, as I said before I working on video in order to describe my problem, hopefully I will finish it today.

Actually I'm working on this issue. I want completely re install my OS and start from scratch. Also I will create some video and add it to my next post. Thanks for now.

I try it already and it's still doesn't working.

Hi.

OS: Win7 64 bit
Arduino software v0022
Azteeg 3D Printer Controller Atmel ATmega 644P with FT232RL FTDI USB chip

1. When I trying to upload MARLIN firmware following error appears:
Binary sketch size: 51518 bytes (of a 63488 byte maximum)
avrdude: stk500_getsync(): not in sync: resp=0x00 ...