Unfortunately my issue is not that simple. I had checked to make sure the wires were set correctly, and they were. I also observed that the heated bed would reach the correct temperature and stop heating.
I have flashed my board and now it seems to be completely dead. When I plug in my USB I see no ...
Search found 2 matches
- Thu May 07, 2015 7:01 am
- Forum: Extruder
- Topic: Extruder heats past set point
- Replies: 3
- Views: 5433
- Mon May 04, 2015 4:50 am
- Forum: Extruder
- Topic: Extruder heats past set point
- Replies: 3
- Views: 5433
Extruder heats past set point
Howdy - I have finished building my Prusa I3 ( with the Sanguinololu board) and I am having an issue with the extruder heater. When I turn on the printer the nozzle starts heating up, even if I have it disabled in the Repetier software. It will heat to 200 degrees, then continue heating. It has ...