Geeetech

No the build instructions still has the diagram wrong. See page 67. On page 79 it shows the connector in the proper orientation, but the diagram on 79 is still wrong. I am looking at the document on the following link:

http://www.geeetech.com/Documents/Delta%20Rostock%20mini%20G2&%20G2s%20building ...

What is the link to the updated manual? The manual I've been using still has the old diagram and shows the 2-pin connector in Fan3.

There is a problem with the wiring diagram of the GT2560. I have a G2S and I was trying to connect the fan for hotend at FAN-PWM with the 2-pin extension wire. The wiring diagram in the build instructions and on the following page have the connector reversed.

http://www.geeetech.com/wiki/index.php ...

I think I had the same problem when I made x > 19

I have the same problem. I thought I had the bed plane adjusted well, but the auto-leveling collided with the bed and broke the arms off. I even had set the z-axis height where the 0 position was about 1/2mm above the bed. I had adjusted the 3 reference points and they were all within 1 index card ...

Is there a way to increase the time it stays locked?

I am trying to perform the step "Define the final Z axis height". The home button works fine, but after a few seconds of the motor idling the z position will drop a little. If I give it the command G0 X0 Y50 Z2 it will move to the proper position but before I can measure the distance to the bed it ...

I am having the same problem. How do you "so please adjust the hot bed plane"? Do you adjust this by adding washers or something under the end-stop screw.

I didn't find any instructions for what to do with parts 39 and 40 the small heat sinks. Where do they need to be installed?

I just finished the assembly and I am following the software instructions to "Define the initial Z axis height". I can't seem to lower the Z axis using the manual buttons. I get "Printer stopped due to errors." In the console above it lists Error:1 and Extruder switched off. MINTEMP triggered !. I ...