Geeetech

Thank you for these. Great work.

Hi Eric,

Thanks for the reply.

Unfortunately I have double checked all end stops and they all operate properly and are in to correct sockets on the board.

I swapped the Z min stop to NC and flipped the probe down and pushed the carriage all the way up manually to get this output from M119

20:50 ...

Hi! Thanks for your answers, I did check the endstops and they are correctly installed, one stepper motor did have a little strugle to move, which I fixed, but still didn't solve the problem, when I move manually from the display one axis in the smallest increments, it starts going and won't stop ...