Geeetech

Hello Mark,

If you would, please send it to me as well - I'd love to give it a try.

Thanks,

Jeff

Hello Brent,

I'm pretty sure my problem was not wiring, but a firmware issue. I jammed up the first extruder pretty good (was able to unclog later) and started using the second one. With multiple versions of Repetier I ran into the problem - so I don't think it has anything to do with the version ...

Hello Brent,

I had a similar problem - it seems to behave badly shaking its way to the top and ignoring the endstops. I purchased another GT2560 and replacement A4988 (stepper motor boards), but the problem remained. It didn't do it all the time, but it sometimes took 10-20 power cycles to get it ...

Hello Mark,

The thermistors all seem to read the right room temp. The hotend fan is working (but there is an error in the instructions - it has you connect the PWM fan to ground and sense - no harm, but that is probably why so many people can't get it to work). I turn on the hotend fan to full ...

Hello Mark,

I got the nozzle cleaned out and got some test prints. I'm using PLA at 190 and have a glass bed set to 60, but I think that the hotend is way too hot... The model I'm printing is still liquid 10+ layers down from the printhead and is getting deformed as the new material sticks to it ...

After I changed the polarity, the motor was going in the right direction. I did try the tension on the extruder drive and played around with the temps, then I disconnected the tubes and tried pushing by hand. Nothing came out of the nozzle, but some leaked out between the top of the hot block and ...

Hello Mark,

I got it this time, thank you. I compiled and burned, but it didn't make a difference...

I looked up the motor specs and it suggested a 1.5amp setting. I changed the voltage on the pot to 1.5V (which I think is 1.5amps) and the stepper motors are now moving. All of the pots on the ...

Hello Mark,

Could you please resend it to me - it didn't come through. Either that or a link would be great.

Thank you,

Jeff

Hello,

I recently purchased a G2S kit and after a few bumps have it pretty close to working. I am having some problems with both extruders. At first one was working, but the direction was backwards (extrude causes retraction), then after a while it stopped feeding. The motor still makes noise and ...