Hello,
I'm not sure if my last reply went through or not, but it's been a few days, so I'll reply again.
I did test to see if there is a short on the extruder motor pins and on the main board as you asked.
As a stepper motor has two coils, each coil had a small resistance indicating that it was ...
Search found 2 matches
- Thu Oct 08, 2015 8:13 am
- Forum: Extruder
- Topic: Prusa I3 X Extruder not working
- Replies: 10
- Views: 31305
- Wed Sep 30, 2015 11:15 pm
- Forum: Extruder
- Topic: Prusa I3 X Extruder not working
- Replies: 10
- Views: 31305
Prusa I3 X Extruder not working
Hello,
I have a Prusa I3 X
The extruder motor does not move, even without filament. I confirmed that the motor is working by plugging in the Extruder motor to the Y axis port and sending it commands through Repetier and through the LCD move controls. I also confirmed that the motor driver works ...
I have a Prusa I3 X
The extruder motor does not move, even without filament. I confirmed that the motor is working by plugging in the Extruder motor to the Y axis port and sending it commands through Repetier and through the LCD move controls. I also confirmed that the motor driver works ...