I have an issue with my prusa I3, iduino/ramps 1.4
It will not be recognized by any computer when the ramps is installed. This has been tested with 2 ramps, 2 iduinos, and 4 computers. I am out of ideas. The iduino is recognized with the ramps disconnected. Have rewired following instructions over ...
Search found 2 matches
- Fri Oct 09, 2015 2:05 am
- Forum: Firmware
- Topic: Prusa I3 not working.
- Replies: 0
- Views: 3607
- Mon Oct 05, 2015 1:02 am
- Forum: Control Board
- Topic: Not operational with ramps
- Replies: 0
- Views: 3352
Not operational with ramps
I am at a loss. I have had this printer for 3 months and still cannot get it working. I have the prusa I3, running with a 2650 and a Ramps 1.4 .
As of currently, the printer:
Cannot connect to any computer with ramps installed on the iduino.
Is not recognized at all.
No LCD power.
No response ...
As of currently, the printer:
Cannot connect to any computer with ramps installed on the iduino.
Is not recognized at all.
No LCD power.
No response ...