Geeetech

Hello guys, another painfull story with a "piece of tech"... I am in the club also.

So i had a confilct with the Geetech guys about what is going on with this left side problem and voila we have an official answer. I hope this helps all of us:



Hello
Thank you for cantacting us.
1.Auto Bed ...

Hello! nice work. Thank you for feeding us with ready stuff.

I have a gt2560 A motherboard on a prusa i3 pro b and the following problems occured after your firmware update while working on a way to make the sensor to work.

a) i dont see anywhere the gt2560.h to change the 32 pins in arduino ...

Yes, i know these settings allready but ther system doesnt respond to any tick change. The fan is always on with the same speed. These settings i am using from the beggin. This is why i am wondering what is wrong... MAybe the firmware?

yes this is reasonable that you say but i cannot understand why it works from start, without any heat, in room temperature. the fan and the board is for dimmer fun with 3 cables not two. So why not working in better way??? MAybe i have to set up something in firmware?

Hello, i recently bought an i3 pro b. I am very happy untill now. I have a question, is it normal for the fan of extruder to work all time? When i press the power button it starts working untill press the power off again. I tried to set up the speed or something but nothing changed. It seems to work ...

Hello again, i was wondering if there is some ready config for the same bodel but for cura, not repetier! Is anyone know if i3 pro b can play with cura 15.04.3??


Thank you!

Ok, well, thank you! I have an i3 pro b printer. I will give a try to your config.

Hello friends, do you know if these settings are good for nozzle 0.4 too???