Geeetech

Most helpful wiccan2
I am only using one extruder at the moment. So for the time being I shall use those ports. I would like to alter the firmware to swap over the port allocation. Thus Repetier will show the bed temp under the bed control slider. Have not worked out where/what to alter in the ...

Hi William
I have moved the bed power and its thermister to extruder 2. It works correctly (using extruder 2 slider in Repetier). This tells me thermister and heat bed are working correctly.
The problem must be with the electronics controlling the switching on and off for the heat bed. As I said ...

Set bed_maxtemp to 50. Connected bed, temp went up past 50 error come up Maxtemp_bed. Bed continued to get hotter.
Back to drawing board.

I do not know if there is a short on the board a visual check does not show any burn marks.
Everything else appears to be working ok. I am printing with pla on a cold bed at the moment and that is going fine.
I have been looking through the configuration.h settings and I see I can set the bed ...

Hi William
I have checked out the post. For Bed temp.
With thermister in it shows 21/0.
With thermister removed it shows 21/0 & err. MINTEMP Bed.
With jumper in its shows 0/0 Err MAXTEMP BED.

During this time the red led for the Bed is always on. Which tells me that power is being supplied to ...

I have a Geeetech Delta G2S.
I have been printing successfully for months. Had some problems with movement on the Z,X axis sorted that the bearings in top pulley`s had collapsed.
Printing was going well but I noticed that the smell of the pla was stronger than normal.Print finished and found that ...

Thanks for that Mark.
I also realised that by taking out the feed tube to the hot end helps. It is a tight fit and is easier to feed the filament in this way.
Up and running now getting to grips with all the printing settings.

I have just built my first 3D printer a Delta Rostock mini G2s, calibrated and ready for my first print. I am using Repetier-Host V1.6.1
My first problem is getting the filament in to the print head. I assume it feeds in via the top connector on the Extruder motor. I can only feed in about an inch ...