Geeetech

Thanks for your reply Mark.

I changed them to 1.1 volts and i work a bit better. But after 8 to 9 hours it happend again. I raised the voltage to 1.16 and i did not encounter a shift. So it seems to work. I have not swap any driver yet. I did order a couple of new once so i have some spares.

The ...

I have a problem when i print for a longer period (around 7 hours). I get a unwanted shift in the x and sometimes the y stepper motors.

I check the voltage on the GTM32+5 A4988 board as in this post:
http://www.geeetech.com/forum/viewtopic.php?f=13&t=17038

The voltage was to low. And leveld them ...

When i was building my Geeetech Prusa I3 M201. I also got 5 small heat sinks. And i don't know where i have to place them. And are the blue stickers there to glue the heatsinks?
I also got a "Ejector pin" and i don't what i can/should do with it.

Kind regards,
Barry

I bought my Geeetech Prusa I3 M201 at BangGood.com. And i did not get any operating manuel with it. Only building instructions.
I would like to take a look at a manuel about all the settings that can be set from the LCD display. Is there something like that?


Kind regards
Barry

Hi Mark thanks for your reply. I connected the hotend cables as the "Building Instructions" of Geeetech told me to. And that was in 'hotend 1'. Later on i saw that there was also a 'hotend 0' and a 'thermistor hotend 0'. Changed them to the 0 (zero) one. And it started working. :)

Kind regards ...

Hi Every one,

I just finished the assembly of my Geeetech Prusa I3 M201. And i'm ran into a problem. The hotend won't heatup. On the display it stays 0 (zero degrees). I have checked the connections more than ten times. (see photo)
2016-02-28 15.36.03.jpg

And of course i striped the isolation of ...