Hey guys,
I hope this doesn't double post as I just tried to post this a moment ago and can't find my original post anywhere. First off I should state I recently purchased a Geeetech Prusia i3 Aluminum and have just finished construction. I needed to reverse my axis for both Y and X and jumped into ...
Search found 2 matches
- Tue May 03, 2016 12:48 pm
- Forum: Firmware
- Topic: Getting an error in Arduino 1.6.7 every time
- Replies: 1
- Views: 4923
- Tue May 03, 2016 12:42 pm
- Forum: Firmware
- Topic: Always getting an error when trying to upload my firmware
- Replies: 1
- Views: 4995
Always getting an error when trying to upload my firmware
Hey guys,
I followed the steps on this thread to the letter: http://www.geeetech.com/forum/viewtopic.php?f=20&t=16433
Unfortunately every time I attempt to upload the Configuration.h file in order to reverse the direction on my x and y axis I get the following error:
exit status 1
#error Oops ...
I followed the steps on this thread to the letter: http://www.geeetech.com/forum/viewtopic.php?f=20&t=16433
Unfortunately every time I attempt to upload the Configuration.h file in order to reverse the direction on my x and y axis I get the following error:
exit status 1
#error Oops ...