Geeetech

Hello all, I am working on a project and I have some questions about different manufacturers of PLA spools. Which company makes thin spools; my PLA spool is 2.7" thick and i'm looking for one at least as thin as 1.7". Can anyone help?

After examining the error more closely it appears that fro about three seconds all power is cut to outputs ie. fans, heaters, motors. the red heater light turns off, the steppers spin freely as if without power, and the fans stop turning the orange strobing lights that indicate data are still on ...

okay so i purchased another gt2560 board and uploaded firmware per geeetech support's link so i know the FW is the right one and I'm still having trouble. I adjusted the pots on the drivers and no fix. To me this just leaves the steppers, could they be failing intermittently? Either the X or Y ...

here is the problem I'm having:

Same error with your link so i'll try my laptop next. Any other suggestions?

Hi, I'm attempting to upload Marlin onto my GT2560 controller for my Euroway Prusa i3 Pro B. However when I attempt to upload or compile it displays this error:

In file included from /Configuration_adv.h:689,
from /Configuration.h:1129,
from /Marlin.h:44,
from blinkm.cpp:28:
/SanityCheck.h:38:4 ...

Do you mean I should try changing drivers to a different slot like say switching X-axis and Z-axis to see if the problem changes - that would identify if one driver was the problem! Or do you mean I should buy new drivers and swap all of them out?

Hi all, I have a prusa i3 pro B made out of laser cut wood with a GT2560 control board. When I go to print things it starts normally and then after a few layers it will pause for two seconds or so and then start printing again but it will have translated the print to some random location so i have ...

I tried it on the older (1.0.1) version and it just says they don't support any version past 1.6.0 and it can'y compile!

The 1.6.9 was another firmware for a different model printer which doesn't work on mine. when I open the correct firmware which only opens in version 1.0.1 it tells me that the older version is no longer supported by arduino and it won't compile.