Geeetech

DOESN'T ANYONE READ ANYTHING I HAVE SAID?????????????? I HAVE SAID IT 3 TIMES THIS WAS OPENED FOR A GEEETECH TO LOOK AT!!!!!!!!!! I AM WAITING FOR THE GEEETECH TO READ THIS AS I WAS TOLD TO PUT IT HERE BY GEEETECH!!!

as i stated before there is no one who can fix this problem here. And i for sure can not fix it as i am almost blind!!. And i feel its the responsibility of Geeetech to fix this issue as its a manufacture flaw. It can be a serious fire risk and Geeetech need to see this, as if a fire is caused by ...

Not possible cos no one does that stuff here, where i am. plus this is for support not for the community.
Plus there is more damage and possible fire risk.

Hi there

My control board has failed it is a GTx2560 board with my Geeetech Prus I3 x brought on 30 of may 2016

what has happened is the connection to the hotbed on the board has burnt out and has failed. i have attached photos. it suddenly happened during a print where the bed was set to 70c ...

Hey William

i already deal with Support modification with Craftware. They give you the ability to remove/add supports all you want. so far its been going well. Had a few issues but i am still changing it and supports a almost as good as simplify 3D.

it would help alot as reading manuals and see ...

Hi William

Sorry for the late reply didnt get the email that you replied to me. The problem i am having is when i use Repetier-Host the support material is extremely hard to remove to the point where you almost or in one case i had broken the print. Currently i am using Craftware's software and i ...

Hi William

I'm using Repetier-Host? But I am having major issues with supports with slicer3d. Problems to the point where by the time you get the supports off you've destroyed print. All my research has found that there's major issues with supports with slicer3d and Repetier. So want to use ...

Hey There

Does anyone have a Simplify3D a profile for the Prusa I3 X?

Thanks

regards
Jeremy