Geeetech

I used the correct version of the firmware for my G2S Pro.
The temperature of the extruder and heat bed were both 0.

I'm still trying to calibrate the thing.

I purchased it roughly 11 months ago. The support (or lack of) from the seller in Germany was appalling, so I have been spending my time ...

I turn on my printer, connected to it, altered the height, disconnected. Opened the firmware to change the height there too, uploaded it to the GT2650 and exited out of that, went back into repetier, connected and homed the printer, then used preset 1 to bring it to within 2mm of the bottom and all ...

Excellent tip regarding plugging in the extruder motors to the stepper axis motor ports.
I have found a faulty stepper driver so far, butat least it is now extruding for me to work with.
Any idea how I go about getting a replacement (stepper driver chip) faulty part under the geeetech 3 year warranty?

I have tested the cables with a continuity tester on all 4 wires on both leads from the extruder motor all the way down to the plug into the GT2650 board.
When I slice a print and start the job, some filament comes out of the hot end due to the heat, but the motor at the top does not turn at all ...

You have had ample time to consider this, what is the outcome?

Hi,

I think when you say "invert the connector" you may be talking about the wire connector and to push the wires out and back into the connector in reverse order, as these little 6 pin connectors only go in one way at the stepper motor end and I think maybe at the GT board end.

That does sound ...

G2Spro-firmware.jpg My G2S Pro has never worked and /I bought it in may and I am still waiting for parts from Geeetech themselves.

My problem is the X axis. It goes the wrong way, even after changing the true/false statements in the firmware.

Accrding to this pciture of theconfig.h file I cannot ...

Can you organise this forum by hardware, then sub categories??

It would make it much easier to find things specific to thedevice you own or several devices.