Geeetech

I have some problems with printing. So when I start to print with repetier host, it will first heat bed and after that extruder. But just before extruder reaches temperature, repetier host is giving error: "Printer stopped due to errors. Fix error and use M999 to restart (Temperature reset. Set it ...

Thanks, I will try that one. At the moment I'm using that modified Marlin fw, and with this new bracket I need to change some sensor probe points?

I have now used 3D Touch sensor ~ 2 months and it is still working fine. I had one issue with sensor that it was going into error mode after start, but I got it working again by adjusting pin height and putting some teflon tape into pin adjustment screw (thread).

Btw, does anyone know, that is ...

I uploaded firmware from 1st page --> 3D touch sensor started to work . Will do more testing tomorrow...

Thanks . I'm sure that my wirings are ok, so that cannot be reason why sensor is not working.

When I was googling I found out this video from youtube (not mine): https://youtu.be/gFBjkMAkEbA. So we are not only one who has problems with it...

Can someone from Geeetech staff comment this?

I purchased 3D touch sensor to my Prusa I3 Pro B and today I installed it to printer, but I was not able to get it working. When I power up printer, pin is mowing 3 times, but when I try to send any custom G-codes, nothing happens. What should I do / check next to get it working? All needed firmware ...