Search found 6 matches
- Sun Feb 26, 2017 10:56 pm
- Forum: Firmware
- Topic: Latest Marlin bugfix-1.1.x branch for PI3 Pro B
- Replies: 187
- Views: 302716
Re: Latest Marlin RCBugFix branch for PI3 Pro B
ok, thanks for the reply anyway
- Tue Jan 24, 2017 1:44 am
- Forum: Firmware
- Topic: Latest Marlin bugfix-1.1.x branch for PI3 Pro B
- Replies: 187
- Views: 302716
Re: Latest Marlin RCBugFix branch for PI3 Pro B
First off, much thanks for all efforts, well appreciated!!
Query: will this firmware and the latest config.h work as-is for the dual extruder on the pro-C as well? I'm relatively new to this and have been (and am still) struggling a bit to find the correct offsets for both the extruders so they can ...
Query: will this firmware and the latest config.h work as-is for the dual extruder on the pro-C as well? I'm relatively new to this and have been (and am still) struggling a bit to find the correct offsets for both the extruders so they can ...
- Wed Dec 14, 2016 9:00 pm
- Forum: Extruder
- Topic: Extruder fan and spring settings
- Replies: 7
- Views: 15470
Re: Extruder fan and spring settings
Its the connector next to fan 3 on the gt2560 and is marked PWM on the board, but mine doesn't work either, probably has to be enabled in the firmware but haven't got to round to investigating yet
- Sun Dec 11, 2016 11:55 pm
- Forum: Extruder
- Topic: Extruder fan and spring settings
- Replies: 7
- Views: 15470
Re: Extruder fan and spring settings
Don't think that connection exists on the GT2560 board, correct?Mark wrote:The extruder fan, plug it in the PWM fan connector and you can control it through the repetier host.
EDIT: sorry for the unnecessary response, connector 14 is a PWM fan connector
- Sun Dec 11, 2016 11:52 pm
- Forum: Extruder
- Topic: Extruder Fan is Alway On!
- Replies: 4
- Views: 8231
Re: Extruder Fan is Alway On!
Yes you are right. But its power is only 1.32W. So I think it's not necessary to do that when not printing. Oh, there is one thing I have to tell you, you must have the fan on when printing or the printing will be effected .
Is it not more desirable to point the fan at the build rather than the ...
Is it not more desirable to point the fan at the build rather than the ...
- Sat Dec 10, 2016 3:14 am
- Forum: Stepper Motor
- Topic: Common issues :wrong motor direction,Endstop hit...
- Replies: 49
- Views: 269520
Re: Common issues :wrong motor direction,Endstop hit...
Prusa I3 up and running. All motors checked and running when connected, except Z axis right hand motor runs in opposite direction to left hand - even when swapped round. Forum shows masses of downloads to cure this. Any very simple solutions please?
Modify the wiring order may cure it ...
Modify the wiring order may cure it ...