Geeetech

Been studying and browsing for many hours now:

https://www.pololu.com/product/1182
The formula for Imax @ Pololu per today states: Imax = Vref/(8*Rcs)
Rcs in the Geeetech knock off boards is 0.068Ohms. So Imax = Vref / (8*0.068) = 1.838 * VRef
This means a Vref of 0.7 gives Imax = 0.7*1.838 = 1 ...

Sure you want to make a slicer? There are so many of them available already - with many advanced options. It sounds like much fun though.
I hope and pray for Gcode enhancements for my Rostock 301 too. Any chance that this can be done too?
The supreme goal of course is to have a slicer that includes ...

Here a sample, that the buttons below i can not see. Slicer have no function in my programm.
https://s28.postimg.org/98h47qc25/Screenshot_19.jpg https://postimage.org/index.php?lang=german
https://s30.postimg.org/juwz289jl/Screenshot_20.jpg https://postimage.org/index.php?lang=german

Same ...

Have a look at http://forums.reprap.org/read.php?178,715936,736152#msg-736152 too!
I find this procedure much clearer than the Geeetech one.

What is missing from Geeetech procedure is some other parameters that can be wrong and need tweekeing - like the Delta_Diagonal_Rod.
When I vary that ...

Same first 2 bugs as raoulito9.
...
M104 S0 ; turn off temperature
G28 ; home axis
M84 S0 ; hold motors
...


M84 S0 doesn't hold the motors for me - at least not from manual control in Repetier host - the command that does hold the motors in manual control is
M17
...


...
M300 S1244 P500 ...

Hi,
could you point me in the right direction concerning bed levelling? I've read and followed the levelling guide, but my printer is constantly off.
I've checked X/Y/Zsteps/mm, I've tuned rod lengths (all measuring 196mm from screw center to screw center), I've updated the diagonal rod in the ...

Hi,Mikael
Yes,you need reflash it.The latest version is 1.0.0.2.
Read this:
http://www.geeetech.com/forum/viewtopic.php?f=20&t=18167

Hi,
I did read that ;) - but typically version numbers go Major.Minor.Patch. When I have a "1.1.0 A", then that is higher than "1.0.0.2"?
Can you indicate what are ...

I've set the Esteps/mm for Extruder3 - unfortunately the other extruders do require another setting in order to push out the same amount of filament!!?
If I have 3 settings for the 3 stepper motors XYZ, why don't I have 3 settings to address each extruder?

@ raoulito9, I know you're printing ...

Hi,
1.You can home all the axis before you order any move.
2.You can try moving Z axis a little after the home(G28) commend,then make some other orders.
3.About the crashing,i guess it's an issue in your slicer setting.Maybe you add a code to disable all the motors,so it must crash into the print ...

Bonjour René,
je suis sur de mon situation ici... j'ai démonté mes heatsink avant - après une blocage. Je n' avais pas inserré mes cables Teflon 72mm, mais seulement 62mm(oops)
Voir le photo: c'est le bout des heatsink.
cordialement,
Mikael
---
Hi René,
I'm quite sur about my situation... I have ...