Geeetech

Hello Cup,

Sorry for my late reaction.
For the photo of the frame, it has been partially disassembled.
The re-seller is going to sent me a new xz frame.

This doesn't result in a proper alignment.
It also have an influence on the rest of the frame.
The sides don't have a 90 degree angle anymore and the rods aren't able to align properly.
My conclusion is that the frame just isn't good.

Regards, Tom

I think it is the threaded rod that is being pushed or doesn't have the correct fit.
The part came with a complete set that I bought from ebay.
Here is the link:
http://www.ebay.nl/itm/192046934761?_tr ... EBIDX%3AIT

Regards, Tom

Hello Bang,

For your information, the printer has been fully assembled.
I made pictures with a protractor as reference.

Picture 01 and 02 are with the y-axis not attached to the rest of the frame.
Picture 03 and 04 are with a fully assembled printer.

Picture 01
01.jpg

Picture 02
02.jpg ...

Who can advise me on what to do?
I have just build the printer but I don't think it will work properly.

Thank you in advance for the guidance..

So I build my Prusa I3.
When building the y axis I checked if the rods, threaded and smooths where at a 90 degrees angle with the front and end plate.
After the build I checked again and found that the alignment (90 degrees) wasn't good anymore. If you look on the front the front plate moved ...