Geeetech

ok, is it enough to check it in Slic3r ? or something more to do ?

i have some x y shifts too
how can simply i check the belt tension ?

the solution is in the firmware, there are good step by step instructions
note: the last arduino environment is not the right one for complitation of this firmware, take 1.0.1

if you need to make some tests about handling arduino programmation before, an arduino uno board, 2 switches, 2 leds, 4 ...

same question, and about fans: where can i plug the filament cooler ? on pwm ?

hello
i just tried to open marlin sketch
i'm surprised geeetech is still on arduino 1.0.1, but obviously 1.8.0 can't compile this software

for prusa i3 pro B , board GT2560 from geeetech design is not in the arduino list
--> the right board to select is Mega 2560 ?