Geeetech

I've had this happen a few times as well. It has required a restart of the software.
I will take some screenshots if it happens again.

There wasn't a dog.gcode file on the card when the printer was delivered. There was a 424.gcode file that I part-printed and that looked like it could have been a dog.

I bought a new card and exported some gcode from the EastPrint3D software and copied the file over directly. After inserting the ...

[quote=William post_id=81807 time=1514367248 user_id=51382]
This problem seems to be caused by the reading of the SD card fault, if it is possible, you should check the SD card module is normal, such as solder joints, wiring ....etc
[/quote]

OK. I'll take a look at the connections of the SD card ...

Hi

I found this post after "bricking" my E180 using the "Update firmware" option in EasyPrint3D.
After downloading the STMicroelectronics software and Firmware using the links provided on this thread and successfully writing the latest firmware V1.13.13 (18th November 2017) to the printer it now ...

Ok.. i have purchased this cheap knockoff and have spent a whole day trying to get it working. now if your reading this and considering buying this - DONT.

I would rather eat a roll of filament and have my rear end heated to 200`c and print that way than go through the pain of trying to get this ...