Search found 5 matches
- Wed Jun 14, 2017 4:08 pm
- Forum: Products FAQ
- Topic: moving nozzle height
- Replies: 3
- Views: 6807
Re: moving nozzle height
G2S Pro
- Wed Jun 14, 2017 3:42 pm
- Forum: Products FAQ
- Topic: moving nozzle height
- Replies: 3
- Views: 6807
moving nozzle height
Hi, I have realised a problem while calibrating the height of the nozzle. I first set the the zero of the nozzle, then I move to another point. When I move back to the first point which I just set zero, the nozzle did not end up in the same position but a lower one. What would be the reasons which ...
- Tue Jun 13, 2017 11:43 am
- Forum: Products FAQ
- Topic: nozzle hitting the heated bed (G2S pro)
- Replies: 4
- Views: 7308
Re: nozzle hitting the heated bed (G2S pro)
I have followed the instructions in the youtube video but still it is hitting the bed. I have check the three points which there is a paper gap between the nozzle and the bed. Also, I have set the bed as concave. Yet it is still not working. Here is the most updated video.
https://drive.google.com ...
https://drive.google.com ...
- Mon Jun 12, 2017 5:49 pm
- Forum: Products FAQ
- Topic: nozzle hitting the heated bed (G2S pro)
- Replies: 4
- Views: 7308
- Mon Jun 12, 2017 2:42 pm
- Forum: Products FAQ
- Topic: nozzle hitting the heated bed (G2S pro)
- Replies: 4
- Views: 7308
nozzle hitting the heated bed (G2S pro)
I have a constant problem of the nozzle hitting the heated bed. I have followed the instructions to do all the calibration. It runs fine with the 4 checks points yet when it comes to actual printing, the nozzle start hitting the heated bed. Is there any solution to this problem?