Search found 5 matches

by IulianM
Thu Mar 14, 2019 3:36 pm
Forum: Control Board
Topic: Replacing GT2560 A+
Replies: 7
Views: 11215

Re: Replacing GT2560 A+

Hi,

I was re-taking yesterday all the measurements. It looks something is bad with either the PSU or with the board. After couple of power-on/power off one of the fuses get burned (the same one). I was trying to connect one by one each connector, powering on and check the fuse; I burned like 10 ...
by IulianM
Wed Mar 13, 2019 3:54 pm
Forum: Control Board
Topic: Replacing GT2560 A+
Replies: 7
Views: 11215

Re: Replacing GT2560 A+

Hi,

I have checked the PSU and I get 12V.
The fuses look ok (measured for continuity).

Anything else I can check?

Thank you!
by IulianM
Wed Mar 13, 2019 12:39 am
Forum: Firmware
Topic: Firmware for geeetech 3D printers
Replies: 388
Views: 16826124

Re: Firmware for geeetech 3D printers




@maciejm
Hi,
you can refer to it:
https://geeetech.com/


Hi,

I have a Pro B with a GT2560 rev A+. As the initial board stopped working at a certain point I have ordered a new one.
What I did:
- used Arduino 1.0.1 as recommended
- upload the firmware
The display shows the printer ready but ...
by IulianM
Wed Mar 13, 2019 12:34 am
Forum: Control Board
Topic: Replacing GT2560 A+
Replies: 7
Views: 11215

Replacing GT2560 A+

Hi,

I own an i3 Pro B printer. At a certain point I shut it off in the evening and very next day did not start at all.
I bought a new GT2560 rev A+ board (identical with the original one).
To upload the firmware I have used the Firmware Toolkit For Geeetech Printer to up-load I3proB_G02_V1.0.04_01 ...
by IulianM
Sun Feb 24, 2019 9:58 pm
Forum: Firmware
Topic: Firmware for geeetech 3D printers
Replies: 388
Views: 16826124

Re: Firmware for geeetech 3D printers


@maciejm
Hi,
you can refer to it:
https://geeetech.com/


Hi,

I have a Pro B with a GT2560 rev A+. As the initial board stopped working at a certain point I have ordered a new one.
What I did:
- used Arduino 1.0.1 as recommended
- upload the firmware
The display shows the printer ready but going ...