Geeetech

William wrote: Wed Feb 13, 2019 11:27 am It is based on the hardware.
When you swap the pins of them,you need to care the hardware also.

The question is: Can you use the the second nozzle heater pins somehow to heat the bed? The GT2560 board bed heater went bad and I need to find pins to use to heat my bed. Is it possible? If so, HOW?

I have the same problem on my 301. I have had mine for about a year or so now just sitting on a shelf collecting dust. I will pull it down and fix these problems. who did you contact again on getting the kit? Maybe William can help me get this kit?

Now how about changing the E1 over to the heat Bed. There are different pin configurations in the ultimaker.pins.

#define E1_STEP_PIN 49
#define E1_DIR_PIN 47
#define E1_ENABLE_PIN 48

//
// Temperature Sensors
//
#define TEMP_0_PIN 8 // Analog Input
#define TEMP_1_PIN 9 // Analog Input
#define ...

How about a pin number on both the GT2560 and the LCD 12864 and show what each pin does such as the knobs a and b connections ECT.. I think some of the wire ribbons are different out there like the ones Anet used for their 12864 LCD... Can this be done?