Geeetech

Thanks William , looking at the board , looks like it's blown , do you know the name of the Q2 part that i could replace?

Hi , I have a A10 printer ( REV B ) Board . my part cooling fan for filament cooling is no longer working correctly . when i Turn the printer on, the fan runs very slowly without a print running. this continues when printing. have replaced fan , Same issue. even through repeatier host i'm unable to ...

65 for the bed , 200 hot end

Hi Katus ,

I'm using Geeetech's own yellow PLA 1.75mm

Hi ,

after successfully been able to center the printer, ( Help from this forum :) ) now when i attempt to print the 1st layers seem to be all over the place , doesn't stick to the heat bed , and from looking at the nozzle , the filament doesn't seem to flow as well as it did with the first print ...

Thanks Michael , this will help !! , it's getting there now , appreciate the help!!!!

ok, Tried these settings , prints still way off to the right on the heat bed and off it.

thanks ,

i'll try this , my heat bed is just over 220 , so i'll modify the numbers to reflect that.

thanks for the quick response, i'm a total noob when it comes to 3d printing. How do i go about verifying the parameters ?
i'm using CURA , latest version for printing.

Oh and measured the Bed , 224x224

just to add a bit more to this. when i begin a print the heat bed moves backward to the very ...

Hi , Just received and completed putting together the A10. Starting a first test print and the printer is well off center. Can anyone advise the best way to ensure prints always start centrally ?

Thanks in Advance.