Couldn't just put a version out there that has instructions like "Click the button" no.
Have to have steps like "Align the 12 stones of power on the altar of midnight".
/sigh
Fine.
I guess.
Search found 5 matches
- Tue Dec 11, 2018 7:08 am
- Forum: Firmware
- Topic: Firmware for geeetech 3D printers
- Replies: 388
- Views: 16830298
- Thu Sep 13, 2018 8:57 am
- Forum: Extruder
- Topic: Extrusion Problem (Haunted?)
- Replies: 3
- Views: 7440
Extrusion Problem (Haunted?)
Hello all,
I have been dealing with a very strange issue that I hope you can help me with.
I recently set up my i3 pro w. I had some issues with the Z axis but the extrusion was fine.
Eventually I kinda fixed the Z issue and printed out a perfect calibration cube and 3/4 of a Benchy.
I tried ...
I have been dealing with a very strange issue that I hope you can help me with.
I recently set up my i3 pro w. I had some issues with the Z axis but the extrusion was fine.
Eventually I kinda fixed the Z issue and printed out a perfect calibration cube and 3/4 of a Benchy.
I tried ...
- Thu Sep 13, 2018 7:55 am
- Forum: Geeetech I3 Pro W
- Topic: Z axis can't goes up or down+Abnormal movement
- Replies: 8
- Views: 31052
Re: Z axis can't goes up or down+Abnormal movement
Resolved the issues. Turns out there was a stripped nut on the left brass nut. It caused the rod to bend to the right and out of alignment. I was able to remove the nut (the hole is wrecked) and adjust the remaining bolts so everything is aligned now.
If someone else runs into this problem it might ...
If someone else runs into this problem it might ...
- Tue Sep 04, 2018 9:57 pm
- Forum: Geeetech I3 Pro W
- Topic: Z axis can't goes up or down+Abnormal movement
- Replies: 8
- Views: 31052
Re: Z axis can't goes up or down+Abnormal movement
You can contact the technical@geeetech.com
to send you the stl files for I3-08
This solution would not have helped since I was not able to print.
I was able to partially resolve the issue with lubrication though.
I have to be very careful at the start of my prints since the Z axis has a ...
- Tue Sep 04, 2018 3:17 am
- Forum: Geeetech I3 Pro W
- Topic: Z axis can't goes up or down+Abnormal movement
- Replies: 8
- Views: 31052
Re: Z axis can't goes up or down+Abnormal movement
I am having this issue but it appears that the upper brackets (Part i3-08) is pushing the rods out of alignment. How do I go about getting replacements for this part? I have a feeling that the ones I have are slightly off.
I will try the steps in this thread and let you know the outcome.
I will try the steps in this thread and let you know the outcome.