Geeetech

Look at this pic... wire it as u see there and u will be fine.
U will have to solder it.

As I know (now)...

there are 3 versions of A10 out there. Depending on the GT2560 board version.

Versions of A10:
1. Rev A (1.0)
2. Rev b (2.0)
3. Rev v3.0

A10M is the multicolor version.
The hotend mount looks different too at each version. There are versions with and without preinstalled BL ...

Right... this could fit. Simple to mod.

Thx

Easy... the orange one is the signal one. As I know red and orange here must be swaped.

Didn't know that there are different versions with the same name. I know better now. Thanks!
I do not want to annoy anyone... Sorry for that.

Hi there,

is there someone out there who would share her/his E3D v6 hotend mount?
I did search on thingiverse... but I cant find one.

Need it for the classic A10 (Not A10M etc...)

U got a A10M then... Thats a different printer. We are talking about the A10 here.

Would you make it for the A10 (GT2560 Rev B) too?

Board: GT2560 Rev B
Endstops connector (schematic):


VCC | VCC
Z_MAX | Z_MIN
GND | GND
VCC | VCC
Y_MAX | Y_MIN
GND | GND
VCC | VCC
X_MAX | X_MIN
GND | GND


VCC = 5V (Not needed if you use a voltage devider at 24V for the sensor, be sure to devide the voltage to <=5V)
*_MIN, *_MAX = Signal ...