Geeetech

Thank you most kindly, That diagram and the axis information is an absolute godsend.

Thank you to everyone who got involved and like with theklaus, I hope this information is useful for others who've gotten the new version 3 board.

Or is it the Y axis that goes up?

I've a GT2560 ver 3 board.

When I select auto home it moves up the Z axis and doesn't stop until I reset the printer.

Do you get the power light on the switch illuminate when plugged in and turned on?

If not then start with the PSU as Gerald suggests. but if no light then either the mains cable/plug not delivering the juice or fuse issue at source.

If you get no life, then it looks like a return job for the PSU ...

Thank you Gerald and Gingko for the responses.

I'm in a bit of a bind now, So having taken apart the control box to wire in the 3D touch sensor and find a totally different board to the instructions that are sent out, I have seen that the newer A10 is meant to be a plug and play with the wiring ...

After further research I've found this YouTube clip. https://www.youtube.com/watch?v=_RtsZDbR2po

Can anyone tell if this file for the firmware is legit before I download it?

There is a mention of BL touch reference but I can't find that,

Anyone with this knowledge?

New to the Geeetech products and hope my initial problems are not a sign of the future.

Just received A10 with 3d touch sensor, would have been nice if I was informed whilst buying that I needed an cable extension. I'm following the manual and when I open up the control box I find that my version ...