Search found 7 matches
- Fri Feb 22, 2019 11:14 pm
- Forum: Geeetech A10 Series
- Topic: The A10M hot end setup ...
- Replies: 3
- Views: 8010
Re: The A10M hot end setup ...
I hate this stupid nozzle setup for a number of reasons.
- It oozes horribly - as bad as my Volcano setup with a 0.8mm on it. Always have to grab multiple blobs and strands between prints
- Despite lots of oozing, there's a huge amount of resistance in the hot end, resulting in stripped filament ...
- Sat Feb 16, 2019 3:36 am
- Forum: Geeetech A10 Series
- Topic: A10M Retraction Settings
- Replies: 21
- Views: 133458
Re: A10M Retraction Settings
I don't know if my printer has any issue but I just can't deal with stringing, I've already tried a lot of combinations of retraction distance, speed and coasting with no success
- Thu Feb 14, 2019 3:37 am
- Forum: Geeetech A10 Series
- Topic: A10M Retraction Settings
- Replies: 21
- Views: 133458
Re: A10M Retraction Settings
In S3D the retration works best than cura for this printer but I cant find a solution for this, I'm startit to think this printer is junk.
- Tue Feb 12, 2019 7:18 am
- Forum: Geeetech A10 Series
- Topic: Horizontal and diagonal lines on print - A10M
- Replies: 3
- Views: 6492
Re: Horizontal and diagonal lines on print - A10M
Did you tried lowering the jerk values and printing speed ?
I have no experience with such large parts so I can't say for sure, but it may worth a try. Before I lowered jerk to 8 (default 20), all my printing were ruined because of bad y shifting. For a large part I would even lower it to 0 with ...
- Tue Feb 12, 2019 5:26 am
- Forum: Geeetech A10 Series
- Topic: Horizontal and diagonal lines on print - A10M
- Replies: 3
- Views: 6492
Re: Horizontal and diagonal lines on print - A10M
Thanks for helping, now at least I have a clue, by the way, thanks for your work with 2.0 version.
regards
regards
- Thu Feb 07, 2019 4:56 am
- Forum: Geeetech A10 Series
- Topic: Horizontal and diagonal lines on print - A10M
- Replies: 3
- Views: 6492
Horizontal and diagonal lines on print - A10M
Hello, I have spending months trying to calibrate my A10M but fine tuning seems to be impossible, now the big problem is the vertical surfaces with horizontal and diagonal lines, I have tried: Change temperature, fan speed, extrusion multiplier, layer height and etc..
This problem is only visible ...
This problem is only visible ...
- Thu Jan 24, 2019 10:52 pm
- Forum: Geeetech A10 Series
- Topic: Cura json file for your Geeetech A10M printer
- Replies: 24
- Views: 63399
Re: Cura json file for your Geeetech A10M printer
Hello, you also can paste the material files directly on resources/material.
regards
regards