Geeetech

schnappi wrote: Wed Mar 06, 2019 5:20 am You have a PN

Would you be so nice to send me a PM with the Info, too?

Thanx!

Thanks P_Rhodan, but what version of firmware do you use? because in that video link, guy uses V1.38.61 and I can't find it anywhere. Anyone know where I can find V1.38.61?


I use V1.38.59. If you look on the upload date of the Video, it was 19th of July 2018! At this time was the official ...

Sorry, but the language used in international forums is English. To make it easier for all forum participants and also later for the search, it would be nice if you would stick to it as well.

If you do not speak English, you can also use the Google Translator:
https://translate.google.com/?hl=de ...

david6534 wrote: Fri Feb 22, 2019 2:19 am Yes i have changed the direction with the 1.2 motor tool. The direction is right only the homing direction is wrong.

Then I'm sorry, because otherwise I can not help. Maybe the original poster, which provided the firmware.

even though i have switched the direction of the motors. Can some of you help me with this issue?


Hi, how did you change the direction of the motors? Did you use the Smartto Motor Tool for this?
You can find it here, if you have not used it, please use the new version 1.2
https://github.com ...

I have tested with 3Dtouch and it work like a charme :-) The 3Dtouch is very accurate.
Much better than with the Capacitive Proximity Switch.

First, I had to disassemble the printhead and solder on the small PCB board a pin header, because my printer was not prepared for the 3D touch sensor.
Than I ...

Hi,

the Smartto Firmware V2.0 can you find in the Download section, too. It is under "Software" - "Related Software" - "Firmware Toolkit for Geetech Printers":
https://www.geeetech.com/index.php?main_page=download&download_id=40

Regarding the "new" firmware I have no idea.

Best regards

P_Rhodan

Very good!

Any release date available? When can we get the new firmware?

Thanx!

This has to do with wrong PID settings for the hotend. Badly the A30 firmware do not support PID auto tune. You can only set it manually with the smartto-motor tools (https://github.com/Geeetech3D/Smartto-Tool/tree/master/applications).
Btw. with this tool you can also tune the Extruder steps and ...

That's just a suspicion now. Is it possible that the LCD display was screwed in too tight?
You can open the Control Box below with 5 screws. Unscrew the power supply with the 4 side screws. Then loosen a little bit the 4 screws fixing the LCD display. Now test again.