Geeetech

vert wrote: Wed Nov 13, 2019 9:57 am you need to measure and adjust the probe offset in marlin recompile and flash to change this.

ok I've dont that and changed it via the M851 command. It seems good now, but the bed leveling now is in the wrong places. Is it possible that the x,y offset are hardcoded in the routine?

Hi,

normally the Bltouch is to the left of the hotend, but i switched to an E3D V6 and now my Bltouch is to the right and a bit in front of the hotend. Where can I set the parameters to change the position, so that the mesh bed leveling finds the correct spots again?

Thanks a lot!


Best regards

ok thx thats helps me a bit, but when i google "Hotend cartridge" I'm still not really sure where I can find it on my A10. lets say I do find it... what should be the expected values?

The Geeetech support told me to "check the resistor". Thats all they wrote. Unfortunately I don't really know what to do now and what to look for when I found it. I hope someone maybe has some pictures and suggestions on what to do.

yea everyone should be autotuning there pid for there hotend and bed.

runs pid autotune on bed and then saves it.
M303 E-1 S60 U
runs pit autotune on hotend then saves it.
M303 S200 U


hm, unfortunately the temp is still jumping around again between 207-214... i even saw a short spike to 204 ...

vert wrote: Sun Jan 13, 2019 5:11 pm

Shinobi wrote: Sun Jan 13, 2019 5:09 pm

vert wrote: Sun Jan 13, 2019 5:01 pm prolly needs to pid autotune the hotend and bed everyone should be doing this every machine is slightly different

thanks. how can that be done? any guides out there?

http://marlinfw.org/docs/gcode/M303.html

Thanks, that really seemed to help. Temps are pretty stable now!

vert wrote: Sun Jan 13, 2019 5:01 pm prolly needs to pid autotune the hotend and bed everyone should be doing this every machine is slightly different

thanks. how can that be done? any guides out there?

Thanks for the reply. I will try to do the e-steps calibration. If the PSU is the problem, I expect geeetech to replace mine. I just spend the money on a printer and don't want to invest another 50$ into a broken part...

Hi guys,

I received my A10 yesterday and already did some test prints... There seem to be a few issues, but overall its printing. One thing I noticed today, was that the preheat is very weird. Bed heats up fine to 50° and then the nozzle starts to go to 210°.

When it reaches the 210° it fluctuates ...

Hi, are there any other differences than the dual color print possibility between the A10 and A10M? I found them on ebay for nearly the same price and was thinking about getting the M, instead of the regular A10.

Thanks for some infos