Geeetech

Thanks!

I found a single Hotend suitable for the A10 in my Area and just needed to set it down a bit in the cage, so the nozzle would actually be lower than the coolingfan and air vent.

Is the 2in-1out hotend of the A10m bigger (does the nozzle reach further down) in comparison to the A10 hotend ...

Hi,

it's been a while and i never got rid of the clogging.

What possibilities do i have, at the moment, to convert the printer to a single hotend?

Would the A10 replacement be suitable for my printer?

https://www.geeetech.com/geeetech-a10-a30-a30-pro-a20-3d-printer-24v-printing-head-p-1041.html ...

Hi,

The 2-in-1-out hotend of the A10m is a nice feature, but i would like to have a single hotend as well.

Which hotends would you recommend and how would i have to change the firmware?

Have a nice day!

oldi

vert wrote: Fri Mar 08, 2019 7:37 pm
stock marlin 1.1.8 is total trash nearly all the settings are wrong some as much as 10x to high.

Is this: Firmware for geeetech 3D printers a newer version than stock?

Should i go for your Marlin 2.0 beta?

In both cases i should calibrate e-steps and pid by hand again after flashing?

Thanks for the reply!



1) if your setting a z offset im guessing you have a bltouch if you do the original z end stop must be removed the bltouch is your z end stop your giving it 2 inputs with both attached.
stock marlin 1.1.8 is total trash nearly all the settings are wrong some as much as 10x ...

Hi everybody,
nice Forum with very helpful threads!

Info:
I have a new A10m and some problems with it.
I use (stock) Marlin 1.1.8. <- should i flash a newer one?
I already calibrated the e-steps, which helped quite a lot (extruded only 75% of 100mm filament - was set to 340.0 and is now set to ...