Geeetech

I finally managed to get the printer working again.

I screwed off the whole heating block etc. once more, flashed the firmware with the 1.1.8 version and reinstalled Cura.

Actually still don't know where the problem was. I assume you are right with the levelling guess. Just happy it works again ...

Thanks for your reply bta!

Unfortunately I've cleaned bed and Nozzle right before the print.
For me as newbie it looks s like the filament is bending upwards towards the Nozzle. However as I made sure there is no filament stuck in the tube and the Nozzle itself is free I can't localize the reason ...

Thanks a lot for your reply vert!

I followed your advice and tried to readjust bed and gantry as well as axchanged the tube and pushed it in until stop.
Now my print has imrpoved a little but is still not back to normal.
The skirt and straight lines were printed better but when it came to support ...

Hi guys,

I have an issue with my a10 printer for a couple of days now. My PLA is curling and sticking to the nozzle so my first layer won't print properly. It already starts when I am printing the first skirt line. A few days ago everything was fine and I did not do any changes since then. I ...