Geeetech

Right - I get that. Is there an official place I can make that request? Because if anything would benefit from a color mix, it'd be things printed with vase mode! Or is me talking to you about it as official as it gets and you'll forward on my feature request?

I tried printing out the little tree in normal (non-vase) mode and the color mix was applied properly. So it's definitely a vase mode issue.

Now, is there somewhere that I can submit a feature request to support vase mode prints?

I understand that the color mixer likely looks for "layer changes ...

I get that vase mode is not layer-based and yet I still see what looks like a valid layer count on any 3D printing software that I use, like Repetier-Host. Additionally, I still see a large number of mix changes throughout the gcode and yet they seem to be ignored. I have sliced with Cura, Slic3r ...

For sure. See attached. You see tons of mix color changes throughout the g-code, so this might be an issue with the printer's firmware, perhaps?

Thanks, William. You'll note that that is the exact link I included in my original post. The little app is relatively intuitive, so the use of it is not an issue. I was finally able to download the 1.1 version and the little gradient preview is helpful. Unfortunately, it still didn't print out what ...

To be fair, I'm using an older version of Color Mixer (I think it's the original 1.0 Beta; I downloaded it from here: https://www.geeetech.com/forum/viewtopic.php?t=61760).

I'm using the older version because I have tried about 15 times to download the new 1.1 version from here and it is extremely ...

Does anyone know how to convince Repetier-Host (PC version) to properly render the filament in the proper color when using color mixing? Specifically, it does not appear that Repetier-Host pays any attention to the M163 and M164 commands that change the color mix, but maybe I'm not using the proper ...