Hi to everyone ...
(I hope, this is the right place for this post ... if not, pls move)
The issue:
I tried to figure out my correct temperature for the Prints with the Geeetech-Filaments and ... so i used the "Temp Tower" from Thingiverse (https://www.thingiverse.com/thing:2493504).
For those ...
Search found 3 matches
- Sun Nov 24, 2019 11:35 pm
- Forum: Geeetech A20M
- Topic: A20M an Cura Temperature Settings
- Replies: 1
- Views: 3384
- Fri Nov 22, 2019 9:35 pm
- Forum: Software
- Topic: Adding Filament Settings to CURA 4.4
- Replies: 2
- Views: 10751
Re: Adding Filament Settings to CURA 4.4
Hi William ...
... that was fast
THX for the Screenshots.
(Where do you buy the filament with 5.00€/500gr. ?
... that was fast
THX for the Screenshots.
(Where do you buy the filament with 5.00€/500gr. ?
- Thu Nov 21, 2019 6:42 pm
- Forum: Software
- Topic: Adding Filament Settings to CURA 4.4
- Replies: 2
- Views: 10751
Adding Filament Settings to CURA 4.4
Hi there ...
... first, this my entry-post in this board and i hope, i've chosen the right Thread.
I bought me a Geeetech A20M and tried my first steps. First of all, i'll print a "calibration Cube" and therefore i use "CURA 4.4".
Adding the a20M-profile in it was easy, i found it here in the ...
... first, this my entry-post in this board and i hope, i've chosen the right Thread.
I bought me a Geeetech A20M and tried my first steps. First of all, i'll print a "calibration Cube" and therefore i use "CURA 4.4".
Adding the a20M-profile in it was easy, i found it here in the ...