Geeetech

Hi,

After the update i make only 4 preheating test, and no error appeared. I will try today another preheating test in order to watch if the error occur again.

But another question,i don't understand, when I upgrade with the firmware tool, it has an error with the G05 (bltouch) hex file and not on ...

Hi,

I try the firmware on the official website, i can up the firmware G04 but not the G05 ( objet error ). The heating error is a random error. I send an email at geeetech.

Wait and see for solving the problem.

I will give the answer of geeetech here...if it can help someone else...

Hi, Thank you William.

I have check the thermistor connection, it correctly connected.
It happens with sd card and USB connection, i try with CURA and S3D
I have Autotune the PID four time with C8 value.

I can print only if after heating I change manually my temp value lower than the M109 value ...

Hello everyone,

Here I have an a20m (replacement of my u20) recently with bltouch, first impression with the test file of the card sd ok the first time, but since impossible to launch something else slicer on s3d or cura, even the test files will not launch more. I flash the firmware with that of ...